Command: RS (Retrieve Settings). The HSM must be in the Secure Authorised state.
Function: To read the alarm, host port and security settings from a Smartcard. The user is then prompted to use these to overwrite the existing HSM settings. If the settings on the Smartcard were saved using a configuration command (CL, CH or CS), then only those settings are overwritten.
Inputs: Overwrite
alarm settings: Y/N.
Overwrite host settings: Y/N.
Overwrite security settings: Y/N.
Outputs: The Alarm, Host and Security settings stored on the Smartcard are listed.
Errors: Card not formatted to save/retrieve HSM
settings.
Attempt with another card? [Y/N]: card is formatted for LMK storage or
is a licence card.
Card not formatted. Attempt with another card? [Y/N]: card is not formatted
Command only allowed from secure-authorised – the HSM is not in secure state, is not in authorised state, or both.
Example:
Secure-AUTH> RS <Return>
Insert card and press ENTER: <Return>
Temperature
Alarm: ON
Motion Alarm: OFF
Overwrite alarm settings with the settings above? [Y/N]: y
ALARM settings retrieved from smart card
Comms
Mode: BINARY
Message header length: 4
Protocol: ETHERNET
Character format: ASCII
UDP active: YES
TCP active: YES
Number of TCP connections: 1
Well-Known-Port address: 1500
Overwrite host settings with the settings above? [Y/N]: y
HOST settings retrieved from smart card
Enable ZMK translate command: YES
PIN length: 04
Old Encrypted PIN length: 05
Echo: ON
Atalla ZMK variant support: ON
Transaction key support: RACAL
User storage key length: SINGLE
Single DES: DISABLED
Select clear PINs: YES
Enable X9.17 for import: YES
Enable X9.17 for export: YES
Solicitation batch size: 0005
ZMK length: SINGLE
PIN encryption algorithm: A
Card/password authorisation: P Encrypted/Plaintext decimalisation table: E
Decimalisation table checks enabled: NO
Overwrite security settings with the settings above? [Y/N]: y
SECURITY settings retrieved from smart card